H/E Pipes - Junction and Bent
Created by: eswordthecat
Create a pipe layout like the above screenshot, wrench the regular pipes but not the heat exchange pipes.
Wrench the pipes inside the red rectangle by following the sequence indicated by blue arrow.
You can see the junction pipe that we lay earlier is not attached but the new spawn pipes (spawned by wrenching) is attached.
http://tinypic.com/r/35bdp9v/5
Again wrench the pipes inside the red rectangle and follow the sequence indicated by the blue arrow
A bent H/E pipe is spawn at the first but on the second the issue does not occur.
http://tinypic.com/r/33zckrr/5
Now redo the pipe layout shown by the first screenshot image, then wrench the pipes inside the red rectangle following the blue arrow sequence.
As you can see all new pipes has been spawn except for the last one.
It appears that if you finish the pipe installation the gas flows okay even though the junction pipes does not match the layout.
Thank you and have a good day coders!